I haven't built it yet, I did do the design so half the battle is won.
I added it to the upoload pages so you can give it a shot if you like.
Basically I wanted a small metal warehouse type building to add to a layout I am planning. One side will be part of an alley and as a result, the taggers have been busy. I also included five parts to make a swamp cooler for the roof and a two part ventilator fan structure for the roof as well. There is a utilites panel selection that can fit in the back side between the large and small doors. I would suggest either multiple copies to make it thick enough to look right or backing it up to some bits of balsa or styrene. It is tabbed for easy construction, laminating it to a sheet or two of thick cardstock would probably be a good thing as well. When doing this, don't try to laminate the tabs, just use a single exterior copy of them otherwise you will run into problems folding them over.
Jay
treadhead1952
Las Vegas, NV
I'm gonna download it for my N Scale layout. I have to make about 50-60 more buildings for my lay out. I appreciate all the modelers uploading their creations.